Legacy Monitor – How to Adjust High Pressure Alerts

This article will go over how to adjust the percentage set for high pressure alerts.

Alerts at determined percentage over initial pressure at installation. The level of the alert can be set by end user of OFF or at 10%, 15%, 19%, 24%, 28%, 33%, 40%, and 45% over the set level.

Please Note: Sensors come from the factory set to trigger at 24% high.

Step 1) Unplug the power cord from the Monitor (mini-USB Connector)

Step 2) While holding down the UP Arrow, plug the power cord back into the Monitor and it will advance to the next alert level higher (new alert level will display on the screen)

Step 3) Release the Up arrow.

Step 4) If the Monitor displays the upper alert pressure you desire, setting the upper alert is completed. If it is not the upper alert pressure you desire, repeat steps 1 & 2 until you see the desired alert level

Step 5) The high alert function can be turned OFF by repeating steps 1 & 2 after the 45% level is reached.

Step 6) To turn the high alert function back ON, repeat steps 1 & 2 going to the 10% alert level which will display.