Pulse – Vehicle Diagnostics

In this article goes over the Vehicle Diagnostic section and what information you can get from the tools within this section.

Step 1) Using the Up & Down arrows, select Vehicle Settings and press the SEL button.

Step 2) Using the Up & Down arrows, select Advanced and press the SEL button.

Step 3) Using the Up & Down arrows, select DIAGNOSTICS and press the SEL button.

Step 4) Once within the Vehicle Diagnostics section, use the Up & Down arrows to highlight a vehicle (A, B, C, D & E).

Step 5) There are 3 pages of data. Each page has its own specific data. (listed below). Press the SEL button to go to the next page.

Page 1:
ID – Vehicle ID for the highlighted vehicle.
SER NO – Serial Number for the Pulse Monitor.
SW VER – Software Version of the Pulse Monitor.
HW VER – Hardware Version of the Pulse Monitor.

Page 2:
PROD – Product Model Number
VBATT – Pulse Power Voltage.
SENs CT – Total Sensor Count on the highlighted vehicle.
LAST RX – Last transmission from a sensor

Page 3:
AMB RF – Ambient RF at the Antenna location.
LAYOUT – Tire Layout for the highlighted vehicle.