Pulse – How to Add Sensors to Existing Vehicles

In this article we’ll be going over the steps of adding a sensor to an existing vehicle. Please Note: Remove existing sensor from tire valve stem prior to starting.

Step 1) Using the Up and Down arrows, navigate to Sensor and press SEL button.

Step 2) Using the Up and Down arrows, navigate to Add Sensor and press SEL button.

Step 3) Using the Up and Down arrows to highlight the desired vehicle (A,B,C,D, or E) & press the SEL button.

Please note: Only enabled vehicles will appear for selection. To enable additional vehicles, follow the steps in Pulse – How to Enable / Disable Vehicles.

Step 4) Using the Up and Down arrows, navigate to the tire location you want to add a new sensor to. Press SEL button.

Step 5) If a sensor is programed to the tire location, you’ll get a message ‘Position in Use: Delete Sensor?‘. Press the SEL button to confirm delete.

Step 6) Once you confirm deletion, the Pulse will automatically delete the sensor and start looking for the new sensor. Walk out to the tire and put the new sensor on the valve stem.

Step 7) The Pulse will sync up with the new sensor, press the SEL button to confirm the new sensor.

Please note: There is no save option after step 7. Use the Menu button to back out to the Normal Viewing mode.

Step 8) Repeat Steps 4 thru 7 if you need to add multiple sensors.