Legacy Monitor – How to Delete Sensor(s)

This article will go over how to delete sensor(s) on the Legacy Monitor. Please Note: Depending on the style of Legacy Monitor, you will different verbiage on the buttons, either an ‘On & Set’ or ‘Set & Prog’.

How to Delete a Single Sensor/Location:

Step 1) In the Normal Viewing Mode, use the Up & Down Arrows, navigate to the tire location you wish to delete.

Step 2) Press and hold the square button (SET or PROG) for 10 seconds. DEL will appear on the LED read out. DO NOT HOLD LONGER THAN 10 SECONDS.

Please Note: When holding SET or PROG button, the following will happen: After 5 seconds, the green LED will go solid; hold for another 5 more seconds and DEL will appear on LED read out.

How to Delete all Sensors:

Step 1) Press and hold the square button (SET or PROG) for 30 seconds.

Please Note: When holding SET or PROG button, the following will happen: After 5 seconds, the green LED will go solid; hold for another 5 more seconds and DEL will appear on LED read out. Continuing to hold for full 30 seconds deletes all readings and monitor to display ‘No SEn Sor’.